Multiquip Plate Compactor MVC-40G Instrukcja Użytkownika Pobierz pdf (Strona 13)

MVC-40G PLATE COMPACTOR — OPERATION & PARTS MANUAL — REV. #4 (06/06/07) — PAGE 13

MVC-40G — COMPONENTS (PLATE COMPACTOR)

Figure 3. MVC-40G Plate Compactor Components

Figure 3 shows the location of the components and general

maintenance parts. The function of each component is described

below:

1. Hand Lift Handle – When lifting of the compactor by

personnel is required, use this hand lift handle. DO NOT

attach a crane or heavy lifting device to this handle to lift

the compactor.

2. Lifting Bale – When lifting of the compactor is required

either by forklift, crane etc., tie rope or chain around this

lifting point.

3. Handle Bar – When operating the compactor use this

handle bar to maneuver the compactor.

4. Belt Cover – Remove this cover to gain acess to the V-

belts. NEVER run the compactor without the V-belt cover. If

the V-belt cover is not installed, the possibility exist that

your hand may get caught between the V-belt and clutch,

thus causing serious injury and bodily harm.

5. Vibrating Plate – A flat, open plate made of durable cast

iron construction used in the compacting of soil.

6. Vibration Case – Encloses the eccentric, gears and

counter weights.

7. Gasoline Engine – This plate compactor uses a 4-stroke,

air cooled ROBIN EH09-2D gasoline engine. Refer to the

ROBIN owner's manual for engine information.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 61 62

Brak uwag

Multiquip Plate Compactor MVC-40G Instrukcja Użytkownika Strona 13